Ads
related to: uds ignition wiring diagram- Direct-Hit Mobile
Now with all Pro subscriptions
Where speed meets precision
- Direct-Hit Pro
Professional auto repair software
Access to all makes and models
- Buy Now
Purchase Online
Identifix Direct Hit
- Direct-Hit Pro Academy
All access to auto repair info
350+ professional trailing courses
- Direct-Hit Mobile
holley.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1] It is derived from ISO 14230-3 and the now obsolete ISO 15765-3 (Diagnostic Communication over Controller Area Network (DoCAN) [2]). 'Unified' in this context ...
Wire placement is identical to type A, but the center groove is split in two. The OBD-II specification provides for a standardized hardware interface — the female 16-pin (2x8) J1962 connector, where type A is used for 12-volt vehicles and type B for 24-volt vehicles. Unlike the OBD-I connector, which was sometimes found under the bonnet of ...
battery+ through ignition switch 16, 54/15 30 from battery+ direct 30/51 30a from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33
A resistance wire is used in the primary circuit. The distributors in EEC-III (and later) systems eliminate conventional mechanical and vacuum advance mechanisms. All timing is controlled by the engine computer, which is capable of firing the spark plug at any point within a 50-degree range depending on calibration.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Transport-layer services include the transmission of multi-CAN-frame messages based on the ISO 15765-2 multi-frame messaging scheme. It was developed and is used primarily by General Motors for in-vehicle communication and diagnostics. [3]
An ignition switch, starter switch or start switch is a switch in the control system of a motor vehicle that activates the main electrical systems for the vehicle, including "accessories" (radio, power windows, etc.).
An ignition coil consists of an iron core surrounded by two coils (windings) made from copper wire.The primary winding has relatively few turns of heavy wire, while the secondary winding consists of thousands of turns of smaller wire and is insulated from the high voltage by enamel on the wires and layers of oiled paper insulation.
Ads
related to: uds ignition wiring diagramholley.com has been visited by 10K+ users in the past month