Search results
Results from the WOW.Com Content Network
These can manifest only at specific environmental conditions, high clock speeds, low power supply voltages, and sometimes specific circuit signal states; significant variations can occur on a single die. [9] Overstress-induced damage like ohmic shunts or a reduced transistor output current can increase such delays, leading to erratic behavior.
A switched-mode power supply will be affected if the brownout voltage is lower than the minimum input voltage of the power supply. As the input voltage falls, the current draw will increase to maintain the same output voltage and current, until such a point that the power supply malfunctions or its under-voltage protection kicks in and disables ...
However voltage spikes can also have more mundane causes such as a fault in a transformer or higher-voltage (primary circuit) power wires falling onto lower-voltage (secondary circuit) power wires as a result of accident or storm damage. Voltage spikes may be longitudinal (common) mode or metallic (normal or differential) mode.
The voltage drop across the load is proportional to the power available to be converted in that load to some other useful form of energy. For example, an electric space heater may have a resistance of 10 ohms, and the wires that supply it may have a resistance of 0.2 ohms, about 2% of the total circuit resistance. This means that approximately ...
The latter includes power that is unusable, so a power factor of 1 is desirable. A low power factor would mean that the electricity supplier would effectively supply more energy than the consumer's bill would indicate, and suppliers are allowed to charge for low power factors. Reactive power is the name given to unusable power. It does no work ...
Putting a non-microwave-safe material in a microwave oven can lead to chemicals leaching into your food (not good) or the melting of the container, which can lead to burns — or, at the very ...
A voltage sag (U.S. English) or voltage dip [1] (British English) is a short-duration reduction in the voltage of an electric power distribution system. It can be caused by high current demand such as inrush current (starting of electric motors, transformers, heaters, power supplies) or fault current (overload or short circuit) elsewhere on the system.
According to a new study, your microwave is one of the dirtiest appliances in your kitchen and can contain tons of bacteria. Here's what you need to know. The Bacteria In This Appliance Is Worse ...