Search results
Results from the WOW.Com Content Network
In pytest, fixture scopes let the user define when a fixture should be called. There are four fixture scopes: function scope, class scope, module scope, and session scope. Function-scoped fixtures are default for all pytest fixtures, which are called every time a function having the fixture as a parameter runs.
Test fixtures can be set up three different ways: in-line, delegate, and implicit. In-line setup creates the test fixture in the same method as the rest of the test. While in-line setup is the simplest test fixture to create, it leads to duplication when multiple tests require the same initial data.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
Mismatch loss represents the amount of power wasted in the system [dubious – discuss]. It can also be thought of as the amount of power gained if the system was perfectly matched [dubious – discuss]. Impedance matching is an important part of RF system design; however, in practice there will likely be some degree of mismatch loss. [1]
A lighting control system is intelligent network-based lighting control that incorporates communication between various system inputs and outputs related to lighting control with the use of one or more central computing devices. Lighting control systems are widely used on both indoor and outdoor lighting of commercial, industrial, and ...
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Remote Device Management (RDM) is an addition to the DMX512 control protocol for stage lighting equipment, introduced in 2006. DMX512 was developed in the late 1980s as a standard protocol for lighting consoles to communicate with dimmers, but has since been used for more complex applications, including the control of intelligent lighting fixtures.
Moving target indication (MTI) is a mode of operation of a radar to discriminate a target against the clutter. [1] It describes a variety of techniques used for finding moving objects, like an aircraft, and filter out unmoving ones, like hills or trees.