Search results
Results from the WOW.Com Content Network
The single-ended primary-inductor converter (SEPIC) is a type of DC/DC converter that allows the electrical potential at its output to be greater than, less than, or equal to that at its input. The output of the SEPIC is controlled by the duty cycle of the electronic switch (S1).
Figure 1: A simple voltage divider. A voltage divider referenced to ground is created by connecting two electrical impedances in series, as shown in Figure 1. The input voltage is applied across the series impedances Z 1 and Z 2 and the output is the voltage across Z 2.
The henry (symbol: H) is the unit of electrical inductance in the International System of Units (SI). [1] If a current of 1 ampere flowing through a coil produces flux linkage of 1 weber turn, that coil has a self-inductance of 1 henry. The unit is named after Joseph Henry (1797–1878), the American scientist who discovered electromagnetic induction independently of and at about the same ...
A non-isolated Ćuk converter comprises two inductors, two capacitors, a switch (usually a transistor), and a diode.Its schematic can be seen in figure 1. It is an inverting converter, so the output voltage is negative with respect to the input voltage.
A resistor–inductor circuit (RL circuit), or RL filter or RL network, is an electric circuit composed of resistors and inductors driven by a voltage or current source. [1] A first-order RL circuit is composed of one resistor and one inductor, either in series driven by a voltage source or in parallel driven by a current source.
Toroidal inductors and transformers are inductors and transformers which use magnetic cores with a toroidal (ring or donut) shape. They are passive electronic components , consisting of a circular ring or donut shaped magnetic core of ferromagnetic material such as laminated iron , iron powder, or ferrite , around which wire is wound.
A typical 230V, 50hz series choke ballast (inductor) used in older lighting. This example is used for a tanning lamp. It requires a starter switch (below). A lamp starter, required with some inductor type ballasts. It connects the two ends of the lamp to preheat them for one second before lighting.
The two cylindrical metal cases fit into octal sockets; each one contains a 1:1 line transformer, the first is rated at 600 ohms, the second is rated at 15,000 ohms. On the far right is a DI unit ; its 12:1 transformer (with yellow insulation) changes a high impedance unbalanced input to a low impedance balanced output.