Search results
Results from the WOW.Com Content Network
The Advanced Host Controller Interface (AHCI) is a technical standard defined by Intel that specifies the register-level interface of Serial ATA (SATA) host controllers in a non-implementation-specific manner in its motherboard chipsets.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
Intel Rapid Storage Technology (RST) is a driver SATA AHCI and a firmware-based RAID solution built into a wide range of Intel chipsets. Currently also is installed as a driver for Intel Optane temporary storage units. It contains two operation modes that follow two Intel specific modes rather than the SATA standard. The name modes and the ...
PAN—Personal Area Network; PAP—Password Authentication Protocol; PARC—Palo Alto Research Center; PATA—Parallel ATA; PBS—Portable Batch System; PC—Personal Computer; PCB—Printed Circuit Board; PCB—Process Control Block; PC DOS—Personal Computer Disc Operating System; PCI—Peripheral Component Interconnect; PCIe—PCI Express ...
ICH - 82801AA. The first version of the ICH was released in June 1999 along with the Intel 810 northbridge.While its predecessor, the PIIX, was connected to the northbridge through an internal PCI bus with a bandwidth of 133 MB/s, the ICH used a proprietary interface (called by Intel Hub Interface) that linked it to the northbridge through an 8-bit wide, 266 MB/s bus.
Fibre Channel host bus adapter. The term host bus adapter (HBA) may be used to refer to a Fibre Channel interface card. In this case, it allows devices in a Fibre Channel storage area network to communicate data between each other – it may connect a server to a switch or storage device, connect multiple storage systems, or connect multiple servers. [2]
Network-attached storage Hardware / Storage Computer data storage: NAT: Network Address Translation Internet Layer Cisco Internet Protocol Journal: A look Inside Network Address Translators: NBMA: Non-Broadcast Multiple Access (e.g. Frame Relay ATM) Telecom See ATM, Frame Relay and X.25, for examples. NIC: Network Interface Card Physical layer ...