Ads
related to: i beam vs a arm suspension lift for sale california
Search results
Results from the WOW.Com Content Network
The lowered pivot point and longer arm length reduce the change in camber and the effect is far less hazardous than powered swing axles for the rear wheels listed above, where the pivot point is approximately on the same side frame rail. [6] The Twin I-Beam suspension includes an additional radius arm link on each side to control caster. [7]
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle. The shock absorber and coil spring mount to the wishbones to control vertical movement.
With a beam axle, the camber angle between the wheels is the same regardless of its location in the travel of the suspension. A beam axle's location in the fore and aft directions is constrained by one of several suspension components, including trailing arms, semi-trailing arms, radius rods, and leaf springs.
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured the TTB axle for Ford.
The General Motors connection led to one of the suspension's most numerous uses, with a return to Europe for the pre-war Vauxhall Twelve and Vauxhall Fourteen from 1935 to 1938. [6] The post-war Vauxhall Velox of 1949 reintroduced a similar leading arm suspension which is widely described as 'Dubonnet' suspension. [7]
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
Ads
related to: i beam vs a arm suspension lift for sale california