Search results
Results from the WOW.Com Content Network
Stan Williams of HP Labs also argued that ReRAM was a memristor. [21] However, others challenged this terminology and the applicability of memristor theory to any physically realizable device is open to question. [22] [23] [24] Whether redox-based resistively switching elements (ReRAM) are covered by the current memristor theory is disputed. [25]
A memristor (/ ˈ m ɛ m r ɪ s t ər /; a portmanteau of memory resistor) is a non-linear two-terminal electrical component relating electric charge and magnetic flux linkage.It was described and named in 1971 by Leon Chua, completing a theoretical quartet of fundamental electrical components which also comprises the resistor, capacitor and inductor.
In one of the technical reports [3] the memistor was described as follows: . Like the transistor, the memistor is a 3-terminal element. The conductance between two of the terminals is controlled by the time integral of the current in the third, rather than its instantaneous value as in the transistor.
Often the isolation capabilities are inferior to the use of transistors if the on/off ratio for the selector is not sufficient, limiting the ability to operate very large arrays in this architecture. Chalcogenide-based threshold switches have been demonstrated as a viable selector for high-density PCM arrays [22]
Besides differences in the schema, there are several other differences between the earlier Office XML schema formats and Office Open XML. Whereas the data in Office Open XML documents is stored in multiple parts and compressed in a ZIP file conforming to the Open Packaging Conventions, Microsoft Office XML formats are stored as plain single monolithic XML files (making them quite large ...
For example, uncompressed songs in CD format have a data rate of 16 bits/channel x 2 channels x 44.1 kHz ≅ 1.4 Mbit/s, whereas AAC files on an iPod are typically compressed to 128 kbit/s, yielding a compression ratio of 10.9, for a data-rate saving of 0.91, or 91%.
In electronics, cut-off is a state of negligible conduction that is a property of several types of electronic components when a control parameter (that usually is a well-defined voltage or electric current, but could also be an incident light intensity or a magnetic field), is lowered or increased past a value (the conduction threshold).
The initial value of the LFSR is called the seed, and because the operation of the register is deterministic, the stream of values produced by the register is completely determined by its current (or previous) state. Likewise, because the register has a finite number of possible states, it must eventually enter a repeating cycle.