Search results
Results from the WOW.Com Content Network
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
The depth of the bearing seat at the ends of underslung LH- and DLH-Series Joists have been established at 5 inches (130 mm) for chord section number 2 through 17. A bearing seat depth of 7 + 1 ⁄ 2 inches (190 mm) has been established for the DLH Series chord section number 18 through 25. [1]
Half-hipped (clipped gable, jerkinhead [7]): A combination of a gable and a hip roof (pitched roof without changes to the walls) with the hipped part at the top and the gable section lower down. Dutch gable, gablet : A hybrid of hipped and gable with the gable (wall) at the top and hipped lower down; i.e. the opposite arrangement to the half ...
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
Overhangs on two sides of Pennsylvania Dutch barns protect doors, windows, and other lower-level structures. Overhangs on all four sides of barns and larger, older farmhouses are common in Swiss architecture. An overhanging eave is the edge of a roof, protruding outwards from the side of the building, generally to provide weather protection.
Building codes in the U.S. specify ventilation rates as a minimum of 1 sq ft (0.093 m 2) of opening per 150 sq ft (14 m 2) (1:150) with a ratio of 1:300 in some conditions. [8] Warm air rises, so ceiling insulation is designed to have a higher r-value and the insulation is often installed between the ceiling joists or rafters.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.