Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
1. Industrial or Mining Application 2. Equipment Category 3. Atmosphere 4. Temperature The ATEX as an EU directive finds its US equivalent under the HAZLOC standard. This standard given by the Occupational Safety and Health Administration defines and classifies hazardous locations such as explosive atmospheres.
Here are the 5 worst hazmat incidents in Illinois. Semis and trains have transported hazardous materials for years, but sometimes things go wrong. Here are the 5 worst hazmat incidents in Illinois.
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]
IEC 61140: Protection against electric shock — Common aspects for installation and equipment. International Electrotechnical Commission. 2001. (formerly: IEC 536-2: Classification of electrical and electronic equipment with regard to protection against electric shock, 1992) BS 2754 : 1976 (1999): Memorandum.
Unlike its counterpart, the Occupational Safety and Health Administration, NIOSH's authority under the Occupational Safety and Health Act [29 CFR § 671] is to "develop recommendations for health and safety standards", to "develop information on safe levels of exposure to toxic materials and harmful physical agents and substances", and to "conduct research on new safety and health problems".
Occupational exposure banding, also known as hazard banding, is a process intended to quickly and accurately assign chemicals into specific categories (bands), each corresponding to a range of exposure concentrations designed to protect worker health.