Search results
Results from the WOW.Com Content Network
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
The General Motors ignition switch recalls refers to February 6, 2014 when General Motors recalled about 800,000 of its small cars due to faulty ignition switches, which could shut off the engine while the vehicle was in motion and thereby prevent the airbags from inflating. [1]
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
Introduced in 1963 on Pontiac's 389 and 421 cu in (6.4 and 6.9 L) drag racing engines, General Motors fitted it to the 1967 Z/28 before they used it on the L88 427 cu in (7.0 L) Corvette. It eliminated the production breaker-point ignition allowing greater spark energy and more stable ignition timing at all engine speeds including idle.
The engines were also sold for marine and stationary applications. In a 1938 reorganization, Winton Engine Corporation became the GM Cleveland Diesel Engine Division, and GM's Detroit Diesel Engine Division began production of smaller (50–149 cu in (0.8–2.4 L) per cylinder) diesel engines. Locomotive engines were moved under the GM Electro ...
The 4.3 L V6 was retained but was only available on the 1500 and light-duty 2500 series. The "Generation III" small-block V8 engines (based on the LS-series engines) were introduced, with the Express and Savana receiving the 5.3 L V8 (on light-duty vans) and the 4.8 L and 6.0 L V8s (on heavy-duty vans). [9]
The 250 engine continued to be used in GM trucks until 1984, after which it was replaced by the 4.3 L V6 (essentially a 350-cubic-inch (5.7 L) Chevy small-block V8 with the two rear cylinders removed). It was also used in a number of large sedans by Chevrolet of South Africa until 1982.