Search results
Results from the WOW.Com Content Network
From 2012 through 2014, the EPA demolished the E.C Electroplating building, and contaminated soils and concrete from the site were excavated and removed. Approximately 5,700 tons of soil and 1,150 tons of concrete were found to be contaminated; the extracted soil and concrete were replaced with backfill to prevent further contamination from ...
For many years, lead cell batteries were destroyed there and the lead was extracted, leaving the untreated cases on site. An environmental assessment showed that the site was contaminated due to the presence of heavy metals, lead and hydrocarbon pollution. Cement based S/S was employed to successfully remediate 600 tonnes of contaminated soil. [10]
A USBR soil scientist advances a Giddings Probe direct push soil sampler.. Geotechnical investigations are performed by geotechnical engineers or engineering geologists to obtain information on the physical properties of soil earthworks and foundations for proposed structures and for repair of distress to earthworks and structures caused by subsurface conditions; this type of investigation is ...
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
Increasing concrete water content; Increasing concrete porosity; Increasing temperature; Increasing chloride content; Decreasing carbonatation depth; When the electrical resistivity of the concrete is low, the rate of corrosion increases. When the electrical resistivity is high, e.g. in case of dry and carbonated concrete, the rate of corrosion ...
A soil test is a laboratory or in-situ analysis to determine the chemical, physical or biological characteristics of a soil. Possibly the most widely conducted soil tests are those performed to estimate the plant-available concentrations of nutrients in order to provide fertilizer recommendations in agriculture.
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
Groundwater pollution (also called groundwater contamination) occurs when pollutants are released to the ground and make their way into groundwater.This type of water pollution can also occur naturally due to the presence of a minor and unwanted constituent, contaminant, or impurity in the groundwater, in which case it is more likely referred to as contamination rather than pollution.