Search results
Results from the WOW.Com Content Network
The sensitivity of a microphone is usually expressed as the sound field strength in decibels (dB) relative to 1 V/Pa (Pa = N/m 2) or as the transfer factor in millivolts per pascal (mV/Pa) into an open circuit or into a 1 kiloohm load. [citation needed] The sensitivity of a loudspeaker is usually expressed as dB / 2.83 V RMS at 1 metre.
A negative-feedback amplifier (or feedback amplifier) is an electronic amplifier that subtracts a fraction of its output from its input, so that negative feedback opposes the original signal. [1] The applied negative feedback can improve its performance (gain stability, linearity, frequency response, step response ) and reduces sensitivity to ...
The use of voltage gain figure is appropriate when the amplifier's input impedance is much higher than the source impedance, and the load impedance higher than the amplifier's output impedance. If two equivalent amplifiers are being compared, the amplifier with higher gain settings would be more sensitive as it would take less input signal to ...
A minimum detectable signal is a signal at the input of a system whose power allows it to be detected over the background electronic noise of the detector system. It can alternately be defined as a signal that produces a signal-to-noise ratio of a given value m at the output.
The impedance of a line input is typically around 10 kΩ. When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.
Fig. 2. Transimpedance amplifier with a reverse-biased photodiode. In the circuit shown in figure 1 the photodiode (shown as a current source) is connected between ground and the inverting input of the op-amp. The other input of the op-amp is also connected to ground.
Charge amplifier for piezoelectric sensors. Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A ...
These amplifiers are designed to amplify a very small "sense voltage" of 10 to 100 mV, in the presence of very large common-mode voltages of 5 to 30 V. DC precision (low input offset voltage) and high common-mode rejection ratio (CMRR) are distinguishing characteristics of these amplifiers. Some current sense amplifiers measure current flowing ...