Search results
Results from the WOW.Com Content Network
In electrical engineering, a limit switch is a switch operated by the motion of a machine part or the presence of an object. A limit switch can be used for controlling machinery as part of a control system , as a safety interlock , or as a counter enumerating objects passing a point.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow rpm 33h 4. slow rpm 33L rotation left 30L 33R rotation right 30R Indicators 49 flasher unit in 15, 15+, 15/54, +, +15 ...
Reference should be made to codes and standards. For example, IEC 60027, and Letter Symbols in Electrical Technology. Here are tables of widely accepted symbols. They are meant to be a guideline: Using the same symbols for the same things in different articles will increase their consistency, making them easier to understand and to improve.
For example, a surface ceiling light is shown by one symbol, a recessed ceiling light has a different symbol, and a surface fluorescent light has another symbol. Each type of switch has a different symbol and so do the various outlets. There are symbols that show the location of smoke detectors, the doorbell chime, and thermostat.
A high-voltage disconnect switch used in an electrical substation. Such switches are used mostly to isolate circuits, and usually cannot break load current. High-voltage switches are available for the highest transmission voltages, up to 1 million volts. This switch is gang-operated so that all three phases are interrupted at the same time.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
Means that a feature of size is at the limit of its size tolerance in the direction that leaves the least material on the part. Thus an internal feature of size (e.g., a hole) at its biggest diameter, or an external feature of size (e.g., a flange) at its smallest thickness. The GD&T symbol for LMC is a circled L. (See also MMC and RFS.)