enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   The historical connector used by MDA, EGA and CGA graphic cards is a female nine-pin D-subminiature . The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15)

3. VGA connector - Wikipedia

   en.wikipedia.org/wiki/VGA_connector

   In the male connector, this pin numbering corresponds with the cable's wire-and-solder side. The Video Graphics Array ( VGA ) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors ...

4. Audio and video interfaces and connectors - Wikipedia

   en.wikipedia.org/wiki/Audio_and_video_interfaces...

   PAL connector, common in Europe as an antenna connector; S-Video (1 Mini-DIN) SDI - Broadcast grade digital interface over BNC cables; VGA connector A type of D-sub connector standard on most video cards; Mini-VGA Found on some laptop computers; 5 BNC Connectors can also be used to carry the VGA signal as R, G, B, HSync, VSync; Digital Visual ...

5. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

6. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Black, Red and Blue are used for hot wires and White is used as the neutral wire in a 120/208 V circuit. Brown, Orange and Yellow are used as hot wires and gray is used as the neutral wire in a 277/480 V. For grounding, regardless of the voltage, Green (or a bare wire) is used.

7. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   The ATX connector provides multiple wires and power connections for the 3.3 V supply, because it is most sensitive to voltage drop in the supply connections. Another ATX addition was the +5 V SB (standby) rail for providing a small amount of standby power , even when the computer was nominally "off".