enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Distribution transformer - Wikipedia

   en.wikipedia.org/wiki/Distribution_transformer

   Transformers designed for below-grade installation can be designed for periodic submersion in water. [14] Distribution transformers may include an off-load tap changer, which slightly adjusts the ratio between primary and secondary voltage to bring the customer's voltage within the desired range on long or heavily loaded lines. [citation needed]

3. High-leg delta - Wikipedia

   en.wikipedia.org/wiki/High-leg_delta

   High-leg delta (also known as wild-leg, stinger leg, bastard leg, high-leg, orange-leg, red-leg, dog-leg delta) is a type of electrical service connection for three-phase electric power installations. It is used when both single and three-phase power is desired to be supplied from a three phase transformer (or transformer bank).

4. Short-circuit test - Wikipedia

   en.wikipedia.org/wiki/Short-circuit_test

   Currents during such events can be several times the normal rated current. The resultant forces can distort the windings or break internal connections. For large utility-scale power transformers, high-power test laboratories have facilities to apply the very high power levels representative of a fault on an interconnected grid system.

5. Template:Electric transformers - Wikipedia

   en.wikipedia.org/wiki/Template:Electric_transformers

   A navigational box that can be placed at the bottom of articles. Template parameters [Edit template data] Parameter Description Type Status State state The initial visibility of the navbox Suggested values collapsed expanded autocollapse String suggested Template transclusions Transclusion maintenance Check completeness of transclusions The above documentation is transcluded from Template ...

6. Load profile - Wikipedia

   en.wikipedia.org/wiki/Load_Profile

   The power transformer or battery-to-grid are critical aspects of power distribution and sizing and modelling of batteries or transformers depends on the load profile. [1] The factory specification of transformers for the optimization of load losses versus no-load losses is dependent directly on the characteristics of the load profile that the ...

7. Inrush current - Wikipedia

   en.wikipedia.org/wiki/Inrush_current

   Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.

8. Per-unit system - Wikipedia

   en.wikipedia.org/wiki/Per-unit_system

   In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t

9. Buck–boost transformer - Wikipedia

   en.wikipedia.org/wiki/Buck–boost_transformer

   Buck–boost transformers can be used to power low voltage circuits including control, lighting circuits, or applications that require 12, 16, 24, 32 or 48 volts, consistent with the design's secondaries. The transformer is connected as an isolating transformer and the nameplate kVA rating is the transformer’s capacity. [2]