enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. North American Fire Hose Coupler Incompatibilities - Wikipedia

   en.wikipedia.org/wiki/North_American_Fire_Hose...

   [1] [25] 7.5 threads per inch were selected not just as a compromise between the 6, 7, and 8 threads per inch then in use, but because tools and methods had been developed to facilitate the conversion of existing 7 tpi and 8 tpi threads to 7.5 tpi threads, for couplings with an outside diameter ranging from 3 inches to 3 1/8 inches to the new ...

3. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.

4. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   The "Air King" [14] universal air hose coupling, also known as a "Chicago style" fitting, is malleable iron or brass "quarter turn" "sexless coupling" usually found on large pneumatic tools like jackhammers. [6] The fitting is considered "universal", because a common two-lug head is used on all sizes ranging from 0.25 to 1 inch (6 to 25 mm).

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

6. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8 -16 tap, the above formula would produce 5 ⁄ 16 , which is the correct tap drill diameter.

8. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Flat-blade jeweler's screwdrivers and the tips found in 1 ⁄ 4-inch or 6.4-millimeter drive sets are generally hollow-ground. Note that it is this typical chisel shape which allows 9 screwdriver sizes to drive 24 different slotted screw sizes, with the drawbacks of not fitting as closely as a hollow-ground screwdriver would, and increasing the ...

9. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   A chase nipple is a short pipe fitting, which creates a path for wires between two electrical boxes. A chase nipple has male threads on one end only. The other end is a hexagon. The chase nipple passes through the knockouts of two boxes, and is secured by an internally threaded ring called a lock nut. [1] [2]