Search results
Results from the WOW.Com Content Network
At the time that the 10 Gigabit Ethernet standard was developed, interest in 10GbE as a wide area network (WAN) transport led to the introduction of a WAN PHY for 10GbE. The WAN PHY was designed to interoperate with OC-192/STM-64 SDH/SONET equipment using a light-weight SDH/SONET frame running at 9.953 Gbit/s.
This is a list of countries by Internet connection speed for average and median data transfer rates for Internet access by end-users. The difference between average and median speeds is the way individual measurements are aggregated.
10 Gbit/s: 1.25 GB/s: RapidIO Gen2 2x: 10 Gbit/s: 1.25 GB/s: 2008 10 Gigabit Ethernet (10GBASE-X) 10 Gbit/s: 1.25 GB/s: 2002-2006 Myri 10G: 10 Gbit/s: 1.25 GB/s: InfiniBand FDR-10 1× [24] 10 Gbit/s: 1.25 GB/s: 2011 NUMAlink 2: 12.8 Gbit/s: 1.6 GB/s: 1996 InfiniBand FDR 1× [24] 13.64 Gbit/s: 1.7 GB/s: 2011 InfiniBand SDR 8× [23] 16 Gbit/s: 2 ...
Sri Lanka: Sri Lanka Internet Exchange (SLIX) [405] * APIX: Asia Taiwan: Taipei: Taiwan Network Access Point (TWNAP) * APIX: Asia Thailand: Bangkok: NECTEC IIR Public Internet Exchange [406] (NECTEC-PIE, research only) * APIX: Asia Vietnam: Hanoi: EVNTelecom is now Viettel [407] APIX: Europe Bulgaria: Varna: Varna Internet Exchange Euro-IX ...
Gigabit Ethernet was the next iteration, increasing the speed to 1000 Mbit/s. The initial standard for Gigabit Ethernet was produced by the IEEE in June 1998 as IEEE 802.3z , and required optical fiber . 802.3z is commonly referred to as 1000BASE-X, where -X refers to either -CX, -SX, -LX, or (non-standard) -ZX.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
This compares to the IEEE 802.3av standard for 10G-EPON based on Ethernet, which has standardised upstream rates of both 1 Gbit/s and 10 Gbit/s. [8] The 10 gigabit PON wavelengths (1577 nm down / 1270 nm up) differ from GPON and EPON (1490 nm down /1310 nm up), allowing it to coexist on the same fibre with either of the gigabit PONs. [9]
A multi-gigabit transceiver (MGT) is a SerDes capable of operating at serial bit rates above 1 Gigabit/second. MGTs are used increasingly for data communications because they can run over longer distances, use fewer wires, and thus have lower costs than parallel interfaces with equivalent data throughput.