Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
The SOHC eight-valve 4G54 (also known as the G54B) displaces 2.6 L (2,555 cc), with bore & stroke at 91.1 mm × 98 mm (3.59 in × 3.86 in). The G54B for the US market had a cylinder head with additional jet valves to improve emissions (MCA-Jet system).
The G23B engines also featured the MCA-JET improved emissions system with a catalytic converter and three valves per cylinder. For the last two years (until summer of 1989), production was only for the Mazda Porter.
DVT – differential valve tool (for cementing multiple stages) DWOP – drilling well on paper (a theoretical exercise conducted involving the service-provider managers) DWQL – dual-water quicklook log
This version could switch between breathing through two or three valves per cylinder, to combine high top-end power with low-end drivability as well as allowing for economical operation. [1] It was a modification of Mitsubishi MCA-Jet technology which used a secondary intake valve to inject air into the engine for more efficient emissions ...
Those with the later, cleaner yet, "MCA-Jet" system were called G32B. Later, the G32B also came in a fuel injected, turbocharged model. For competition, a version of the 4G32 engine was made with a DOHC eight-valve cylinder head, and fitted with two twin-choke 40 mm (1.6 in) Solex sidedraft carburettors.
I mean, in the moment I remember my Sally Jessy red signature frames went flying up off my face and landed in, like, slow motion. It was insane. It was like a full-face TKO.
Using the PRV method of control, means that the pressure of the feed oil must be below a critical value (usually controlled by other valves which can leak out excess oil back to tank if it exceeds the critical value). The valve opens at a certain pressure and oil is kept moving at a constant rate into the bearing chamber.