Search results
Results from the WOW.Com Content Network
An overhead camshaft (OHC) engine is a piston engine in which the camshaft is located in the cylinder head above the combustion chamber. [ 1 ] [ 2 ] This contrasts with earlier overhead valve engines (OHV), where the camshaft is located below the combustion chamber in the engine block .
The LD9 Twin Cam was a 2.4-liter Quad 4 variant which debuted in 1996 with balance shafts and a redesigned cylinder head. In the mid-1990s, these engines, like their earlier 2.3-liter counterparts, were known for timing chain failures, as well as water pump failures, in which the water pumps were often difficult and costly to access and replace.
The valvetrain layout is defined according to the number of camshafts per cylinder bank. Therefore, a V6 engine with a total of four camshafts - two camshafts per cylinder bank - is usually referred to as a double overhead camshaft engine (although colloquially they are sometimes referred to as "quad-cam" engines). [14]
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
The General Motors 60° V6 engine family is a series of 60° V6 engines produced for both longitudinal and transverse applications. All of these engines are 12-valve cam-in-block or overhead valve engines, except for the LQ1 which uses 24 valves driven by dual overhead cams.
What links here; Related changes; Upload file; Special pages; Permanent link; Page information; Cite this page; Get shortened URL; Download QR code
The name International was first used by Norton both for its newly designed race bikes and also for the TT replica sports roadster in 1932. Overseen by Joe Craig, Arthur Carroll had designed an overhead-camshaft engine for the works racers and although it retained the 79 mm × 100 mm (3.1 in × 3.9 in) bore and stroke of the Norton CS1 the Model 30 International was all new.
What links here; Related changes; Upload file; Special pages; Permanent link; Page information; Cite this page; Get shortened URL; Download QR code