Search results
Results from the WOW.Com Content Network
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
The cable should be grounded only at one end. Grounding the terminators at both may produce a ground loop and can cause network outages or data corruption when swells of electricity traverse the coaxial cabling's outer shield. When wiring a 10BASE2 network, special care has to be taken to ensure that cables are properly connected to all T ...
Structured cabling network diagram. Structured cabling is the design and installation of a cabling system that will support multiple hardware uses and be suitable for today's needs and those of the future. With a correctly installed system, current and future requirements can be met, and hardware that is added in the future will be supported. [1]
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
A rollover cable (also known as a Yost cable, Cisco cable, or a console cable) is a type of null-modem cable that is used to connect a computer terminal to a router's console port. This cable is typically flat (and has a light blue color) to help distinguish it from other types of network cabling.
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [9] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8/U Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.
Several other types of cable existed such as type 2, and type 3 cable. [ 23 ] In later implementations of Token Ring, Cat 4 cabling was also supported, so 8P8C (RJ45) connectors were used on both of the MAUs, CAUs and NICs; with many of the network cards supporting both 8P8C and DE-9 for backwards compatibility.
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs). Crossover cables are sometimes still used ...