Search results
Results from the WOW.Com Content Network
Since electrical energy is a form of energy that cannot be effectively stored in bulk, it must be generated, distributed, and consumed immediately. When the load on a system approaches the maximum generating capacity, network operators must either find additional supplies of energy or find ways to curtail the load, hence load management.
Load affects the performance of circuits with respect to output voltages or currents, such as in sensors, voltage sources, and amplifiers. Mains power outlets provide an easy example: they supply power at constant voltage, with electrical appliances connected to the power circuit collectively making up the load.
is the voltage at maximum load. The maximum load is the one that draws the greatest current, i.e. the lowest specified load resistance (never short circuit); is the voltage at minimum load. The minimum load is the one that draws the least current, i.e. the highest specified load resistance (possibly open circuit for some types of linear ...
Plug load is the energy used by products that are powered by means of an ordinary AC plug (e.g., 100, 115, or 230 V). [1] This term generally excludes building energy that is attributed to major end uses ( HVAC , lighting , water heating , etc.) [ 1 ]
Electricity is the set of physical phenomena associated with the presence and motion of matter possessing an electric charge.Electricity is related to magnetism, both being part of the phenomenon of electromagnetism, as described by Maxwell's equations.
Any electrical load that contains a substantial component of metallic resistive heating elements, such as an electric kiln or a bank of tungsten-filament incandescent bulbs, will draw a high current until the metallic element reaches operating temperature. For example, wall switches intended to control incandescent lamps will have a "T" rating ...
Except in a high-leg delta system and a corner-grounded delta system, single-phase loads may be connected across any two phases, or a load can be connected from phase to neutral. [28] Distributing single-phase loads among the phases of a three-phase system balances the load and makes most economical use of conductors and transformers.
The load line diagram at right is for a resistive load in a common emitter circuit. The load line shows how the collector load resistor (R L ) constrains the circuit voltage and current. The diagram also plots the transistor's collector current I C versus collector voltage V CE for different values of base current I base .