Search results
Results from the WOW.Com Content Network
Modern electric trolling motors are designed around a 12-volt, 24-volt or 36-volt brushed DC electric motor, to take advantage of the availability of 12-volt deep cycle batteries designed specifically for marine use. The motor itself is sealed inside a watertight compartment at the end of the shaft.
All have 1.25 volt DC filaments and directly heated cathodes. Some specify which end of the filament is to be powered by the positive side of the filament power supply (usually a battery). All have glass bodies that measure from 0.285 to 0.400 inches (7.2 to 10.2 millimetres) wide, and from 1.25 to 2.00 inches (32 to 51 millimetres) in overall ...
A cross-section of a proportioning safety valve. A proportioning valve is a valve that relies on the laws of fluid pressure to distribute input forces to one or more output lines. Proportioning valves are frequently used in cars and other road vehicles to reduce the brake fluid pressure to the rear brakes. Due to weight distribution during ...
DC distribution system allows for new ways of thinking regarding operational optimization. The system is flexible and can combine different energy sources such as engines, turbines, and fuel cells. This means that there is the potential to implement an energy management system that takes into account varying fuel prices and the availability of ...
Proportional control, in engineering and process control, is a type of linear feedback control system in which a correction is applied to the controlled variable, and the size of the correction is proportional to the difference between the desired value (setpoint, SP) and the measured value (process variable, PV).
Later thermionic vacuum tubes, mostly miniature style, some with top cap connections for higher voltages. A vacuum tube, electron tube, [1] [2] [3] valve (British usage), or tube (North America) [4] is a device that controls electric current flow in a high vacuum between electrodes to which an electric potential difference has been applied.
The twin Moog servo valves are used to deform the shape of the die on this blow molding accessory designed by BMC Controls Limited. One example of servo valve use is in blow molding where the servo valve controls the wall thickness of extruded plastic making up the bottle or container by use of a deformable die. [9]
A valve spool that controls output flow and pressure; In the steady-state condition, the typical VFS design intent is to control pressure by balancing three axial forces: A spring force due to spring compression by valve position; A magnetic force primarily due to regulated current through the solenoid coil