Search results
Results from the WOW.Com Content Network
Increasing the rotational inertia of the front wheel by increasing the speed of the vehicle and the rotational speed of the wheel will tend to counter the wheel flop effect. A certain amount of wheel flop is generally considered to be desirable. Bicycle Quarterly magazine states, "A bike with too little wheel flop will be sluggish in its ...
For a sample motorcycle moving at 22 m/s (50 mph) that has a front wheel with a moment of inertia of 0.6 kg·m 2, turning the front wheel one degree in half a second generates a roll moment of 3.5 N·m. In comparison, the lateral force on the front tire as it tracks out from under the motorcycle reaches a maximum of 50 N.
This article should really be called bicycle and motorcycle steering geometry. The "geometry" of a bicycle also refers to the length of its various tubes, which is of more concern for ergonomic fit than for its effect on handling characteristics. -- pde 23:30, 13 December 2006 (UTC) Those other parameters could certainly be added.
For a sample motorcycle moving at 22 m/s (50 mph) that has a front wheel with a moment of inertia of 0.6 kgm 2, turning the front wheel one degree in half a second generates a roll moment of 3.5 Nm. In comparison, the lateral force on the front tire as it tracks out from under the motorcycle reaches a maximum of 50 N.
As with four-wheeled vehicles, tyres for motorcycle have a tyre code, which describes a tyre's width, height/width aspect ratio, wheel diameter, load index and speed rating. [16] The most common are: 3 digit number: The "nominal section width" of the tyre in millimetres; the widest point from both outer edges.
“I like to add a half-ounce of lime juice to lift up the flavors of the rum and ginger beer, with a lime wheel on top to add some subtle aroma,” he says. Im also like to tweak a Pimm’s Cup .
Tom Haberstroh and Dan Devine get together, along with five of their favorite stats, to see if this is the most impressive season in LeBron James' awe-inspiring career.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...