Search results
Results from the WOW.Com Content Network
The racks are most commonly made of metal wires, but they can also be found as plastic, polystyrene, foam, fiberglass, and polypropylene. Test tube racks come in the form of a classic rack, an interlocking cube form, a stack-able form, test tube drying rack, slant rack, and 1-well rack. [2] Classic Test Tube Rack
A test tube holder is used to hold test tubes. [1] It is used for holding a test tube in place [2] when the tube is hot or should not be touched. [3] For example, a test tube holder can be used to hold a test tube while it is being heated. [4]
A boiling tube is a large test tube intended specifically for boiling liquids. A test tube filled with water and upturned into a water-filled beaker is often used to capture gases, e.g. in electrolysis demonstrations. A test tube with a stopper is often used for temporary storage of chemical or biological samples.
Laboratory drying rack is usually used to dry up the tube in the laboratory; for example, it can help in drying test tube, boiling tube, and Thiele tube. In addition, laboratory drying rack can hold many types of flask including round-bottomed flask , Florence flask , kjeldahl flask, pear-shaped flask, retort flask, Schlenk flask , Straus flask ...
In chemistry, a retort stand, also called a clamp stand, [1] a ring stand, [2] or a support stand, [3] is a piece of scientific equipment intended to support other pieces of equipment and glassware — for instance, burettes, test tubes and flasks. [4] The typical ring stand consists of a heavy base and a vertical rod, both usually made of metal.
Flat-bottomed flask: A flask with similar uses as the round-bottom flask, but with a flat bottom that allows it to stand on a level surface.; Florence flask: A flask similar to the flat-bottomed flask that has round bodies and either a round bottom or a flat bottom so that one can stand the flask on a level surface.
Büchner flask or sidearm flask—a thick-walled conical flask with a short hose-connection tube on the side of the neck. Volumetric flask —for preparing liquids with volumes of high precision. It is a flask with an approximately pear-shaped body and a long neck with a circumferential fill line.
These tubes are usually made of glass, but can also be made of plastic or metal. They vary in size and purpose. Laboratory sample tubes must not be confused with glass tubing, which can be utilized to carry fluid between laboratory equipment. Example laboratory sample tubes are listed below: Ignition tube; Test tube; Boiling tube; NMR tube