Search results
Results from the WOW.Com Content Network
The use of digital squelch on a channel that has existing tone squelch users precludes the use of the 131.8 and 136.5 Hz tones as the digital bit rate is 134.4 bits per second and the decoders set to those two tones will sense an intermittent signal (referred to in the two-way radio field as "falsing" the decoder). [2]
Continuous Tone-Coded Squelch System (CTCSS), used by many public safety agencies, is available above 400 MHz and below 88 MHz. [6] The transceiver weighs about 12.2 lb (5.53 kg). Available accessories include remote controls, transmit power amplifiers, receive low-noise amplifiers, and ground support equipment.
Elektor SDR [38] Bare PCB and pre-built 150 kHz – 30 MHz ? No Soundcard ADC: 48, 96, and 192 kHz 0/1 USB Yes Yes Yes Elektor AVR SDR [39] Kit and pre-built up to 1 MHz in undersampling ? up to 15 kS/s 0/1 UART via RS2-232 converter or USB bridge Yes Yes Yes ELAD FDM-S1 [40] Pre-built 20 kHz – 30 MHz, up to 200 MHz in undersampling
Software-defined radio (SDR) is a radio communication system where components that conventionally have been implemented in analog hardware (e.g. mixers, filters, amplifiers, modulators/demodulators, detectors, etc.) are instead implemented by means of software on a computer or embedded system. [1]
A noise squelch circuit is noise-operated and can be used in AM or FM receivers, and relies on the receiver quieting in the presence of an AM or FM carrier. To minimize the effects of voice audio on squelch operation, the audio from the receiver's detector is passed through a high-pass filter , typically passing 4,000 Hz (4kHz) and above ...
MDC (Motorola Data Communications), also known as Stat-Alert, MDC-1200 and MDC-600, is a Motorola two-way radio low-speed data system using audio frequency shift keying, (AFSK).
Software-defined radio (SDR) is a radio communication system where components, that have been traditionally implemented in hardware (e.g. mixers, filters, amplifiers, modulators/demodulators, detectors, etc.) are instead implemented by means of software on a personal computer or embedded system. [2]
Selcall (selective calling) is a type of squelch protocol used in radio communications systems, in which transmissions include a brief burst of sequential audio tones. . Receivers that are set to respond to the transmitted tone sequence will open their squelch, while others will remain