Search results
Results from the WOW.Com Content Network
According to the section of tension correction some tapes are calibrated for sag at standard tension. These tapes will require complex sag and tension corrections if used at non-standard tensions. The correction due to sag must be calculated separately for each unsupported stretch separately and is given by:
Marcus's method is a structural analysis used in the design of reinforced concrete slabs.The method was developed by Henri Marcus and described in 1938 in Die Theorie elastischer Gewebe und ihre Anwendung auf die Berechnung biegsamer Platten. [1]
Hogging is the stress a ship's hull or keel experiences that causes the center or the keel to bend upward. Sagging is the stress a ship's hull or keel is placed under when a wave is the same length as the ship and the ship is in the trough of two waves.
The characteristic strength is defined as the strength of the concrete below which not more than 5% of the test results are expected to fall. [ 16 ] For design purposes, this compressive strength value is restricted by dividing with a factor of safety, whose value depends on the design philosophy used.
Palette stacked autoclaved aerated concrete blocks. Autoclaved aerated concrete (AAC) is a lightweight, prefabricated concrete building material. Developed initially in the mid-1920s, it has expanded into widespread use. [citation needed] It is most suitable for producing a lightweight or most cost-effective alternative to traditional concrete ...
The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...
The test is carried out using a metal mould in the shape of a conical frustum known as a slump cone or Abrams cone, that is open at both ends and has attached handles.The tool typically has an internal diameter of 100 millimetres (3.9 in) at the top and of 200 millimetres (7.9 in) at the bottom with a height of 305 millimetres (12.0 in).The cone is placed on a hard non-absorbent surface.
The specific strength is a material's (or muscle's) strength (force per unit area at failure) divided by its density.It is also known as the strength-to-weight ratio or strength/weight ratio or strength-to-mass ratio.