Search results
Results from the WOW.Com Content Network
MasterCard SecureCode uses OTAC to confirm a user's identity One time authorization code as used in Yammer's desktop client. A one-time password (OTP), also known as a one-time PIN, one-time passcode, one-time authorization code (OTAC) or dynamic password, is a password that is valid for only one login session or transaction, on a computer system or other digital device.
Time-based one-time password (TOTP) is a computer algorithm that generates a one-time password (OTP) using the current time as a source of uniqueness. As an extension of the HMAC-based one-time password algorithm (HOTP), it has been adopted as Internet Engineering Task Force (IETF) standard RFC 6238 .
In cryptography, the one-time pad (OTP) is an encryption technique that cannot be cracked, but requires the use of a single-use pre-shared key that is larger than or equal to the size of the message being sent. In this technique, a plaintext is paired with a random secret key (also referred to as a one-time pad).
Roundtrip time = 2 × Packet delivery time + processing delay. In case of only one physical link, the above expression corresponds to: Link roundtrip time = 2 × packet transmission time + 2 × propagation delay + processing delay. If the response packet is very short, the link roundtrip time can be expressed as close to:
HMAC-based one-time password (HOTP) is a one-time password (OTP) algorithm based on HMAC. It is a cornerstone of the Initiative for Open Authentication (OATH). HOTP was published as an informational IETF RFC 4226 in December 2005, documenting the algorithm along with a Java implementation. Since then, the algorithm has been adopted by many ...
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
It is defined as the time it takes for one bit to be ejected from a network interface controller (NIC) operating at some predefined standard speed, such as 10 Mbit/s. The time is measured between the time the logical link control sublayer receives the instruction from the operating system until the bit actually leaves the NIC. The bit time has ...
The two coincide in fact in NRZ transmission; they do not coincide in a 2B1Q transmission, where one pulse takes the time of two bits. For example, in a serial line with a baud rate of 2.5 Gbit/s, a unit interval is 1/(2.5 Gbit/s) = 0.4 ns/baud.