Search results
Results from the WOW.Com Content Network
The heat sink thermal resistance model consists of two resistances, namely the resistance in the heat sink base, , and the resistance in the fins, . The heat sink base thermal resistance, , can be written as follows if the source is a uniformly applied the heat sink base. If it is not, then the base resistance is primarily spreading resistance:
Islamic Golden Age brass astrolabe Brass lectern with an eagle. Attributed to Aert van Tricht, Limburg (Netherlands), c. 1500.. Brass is an alloy of copper and zinc, in proportions which can be varied to achieve different colours and mechanical, electrical, acoustic and chemical properties, [1] but copper typically has the larger proportion, generally 2 ⁄ 3 copper and 1 ⁄ 3 zinc.
Thermal paste (also called thermal compound, thermal grease, thermal interface material (TIM), thermal gel, heat paste, heat sink compound, heat sink paste or CPU grease) is a thermally conductive (but usually not electrically conductive) chemical compound, which is commonly used as an interface between heat sinks and heat sources such as high ...
A thermal interface material (shortened to TIM) is any material that is inserted between two components in order to enhance the thermal coupling between them. [1] A common use is heat dissipation, in which the TIM is inserted between a heat-producing device (e.g. an integrated circuit) and a heat-dissipating device (e.g. a heat sink).
Heat is only produced while each joint is being made, making resistance soldering more energy efficient. Because of these advantages, resistance soldering is common in industries which solder in small spaces such as connectors and wire terminals , and where high power is required, such as desoldering automotive parts.
Aluminum is also much lighter than copper, offering less mechanical stress on delicate electronic components. Some heat sinks made from aluminum have a copper core as a trade off. The heat sink's contact surface (the base) must be flat and smooth to ensure the best thermal contact with the object needing cooling.
Furthermore, the convective heat flux can be determined via the definition of the heat transfer coefficient h, ″ = (), where is the temperature of the surroundings. The differential convective heat flux can then be determined from the perimeter of the fin cross-section P,
Aluminum is the most prominently used heat sink material because of its lower cost. [46] Copper heat sinks are a necessity when higher levels of thermal conductivity are needed. An alternative to all-copper or all-aluminum heat sinks is the joining of aluminum fins to a copper base. [47] Copper heat sinks are die-cast and bound together in ...