enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Deep-cycle battery - Wikipedia

   en.wikipedia.org/wiki/Deep-cycle_battery

   A deep-cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or cranking automotive batteries designed to deliver only a small part of their capacity in a short ...

3. Battery holder - Wikipedia

   en.wikipedia.org/wiki/Battery_holder

   Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...

4. Absorption refrigerator - Wikipedia

   en.wikipedia.org/wiki/Absorption_refrigerator

   Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).

5. Depth of discharge - Wikipedia

   en.wikipedia.org/wiki/Depth_of_discharge

   Depth of discharge (DoD) is an important parameter appearing in the context of rechargeable battery operation. Two non-identical definitions can be found in commercial and scientific sources. The depth of discharge is defined as: the maximum fraction of a battery's capacity (given in Ah) which is removed from the charged battery on a regular basis.

6. VRLA battery - Wikipedia

   en.wikipedia.org/wiki/VRLA_battery

   A 12V VRLA battery, with gel technology inside for deep-cycle application. A valve regulated lead‐acid (VRLA) battery, commonly known as a sealed lead-acid (SLA) battery, [1] is a type of lead-acid battery characterized by a limited amount of electrolyte ("starved" electrolyte) absorbed in a plate separator or formed into a gel, proportioning of the negative and positive plates so that ...

7. Lead–acid battery - Wikipedia

   en.wikipedia.org/wiki/Lead–acid_battery

   The sum of the molecular masses of the reactants is 642.6 g/mole, so theoretically a cell can produce two faradays of charge (192,971 coulombs) from 642.6 g of reactants, or 83.4 ampere-hours per kilogram for a 2-volt cell (or 13.9 ampere-hours per kilogram for a 12-volt battery).