Search results
Results from the WOW.Com Content Network
The RJ45S jack mates with a keyed 8P2C modular plug, [18] [19] and has pins 4 and 5 (the middle positions) wired for the ring and tip conductors of a single telephone line and pins 7 and 8 shorting a programming resistor. This is a different mechanical interface and wiring scheme than ANSI/TIA-568 T568A and T568B schemes with the 8P8C connector ...
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends.
The registered jack or modular jack in RJ11, RJ45 and other similar connectors used for telecommunications and computer networking The telephone jack of manual telephone switchboards , which is the socket fitting the original 1 ⁄ 4 inch (6.35 mm) telephone plug
Splitter (automotive), an aerodynamic feature in cars; Splitter, a table saw safety device; Y-cable, a type of cable containing three ends of which one is a common end that in turn leads to a split into the remaining two ends; Phase splitter
Accuphase was founded by former Kenwood engineer Jiro Kasuga in late 1972. [1] Kasuga was not happy with the views of Kenwood relating to the follower of their High-End Supreme 1 unit (1967). He hired some engineers from other prominent brands ( Marantz , Luxman ) and started Kensonic , with Kenwood as a part owner.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.