Search results
Results from the WOW.Com Content Network
2G refers to the second-generation of cellular network technology, which were rolled out globally starting in the early 1990s. The main differentiator to previous mobile telephone systems, retrospectively dubbed 1G , is that the radio signals of 2G networks are digital rather than analog , for communication between mobile devices and base ...
System Architecture Evolution (SAE) is the core network architecture of mobile communications protocol group 3GPP's LTE wireless communication standard.. SAE is the evolution of the GPRS Core Network, but with a simplified architecture; an all-IP Network (AIPN); support for higher throughput and lower latency radio access networks (RANs); and support for, and mobility between, multiple ...
The Radio Network Controller (RNC) is a governing element in the UMTS radio access network and is responsible for controlling the Node Bs that are connected to it. The RNC carries out radio resource management, some of the mobility management functions and is the point where encryption is done before user data is sent to and from the mobile.
Typical 2G standards include GSM and IS-95 with extensions via GPRS, EDGE and 1xRTT, providing Internet access to users of originally voice centric 2G networks. Both EDGE and 1xRTT are 3G standards, as defined by the ITU , but are usually marketed as 2.9G due to their comparatively low speeds and high delays when compared to true 3G technologies.
Most 2G cellular systems, with the notable exception of IS-95, are based on TDMA. GSM, D-AMPS, PDC, iDEN, and PHS are examples of TDMA cellular systems.. In the GSM system, the synchronization of the mobile phones is achieved by sending timing advance commands from the base station which instruct the mobile phone to transmit earlier and by how much.
GPRS Tunnelling Protocol is the defining IP-based protocol of the GPRS core network. Primarily it is the protocol which allows end users of a GSM or WCDMA network to move from place to place while continuing to connect to the Internet as if from one location at the Gateway GPRS support node (GGSN).
A BSC is often based on a distributed computing architecture, with redundancy applied to critical functional units to ensure availability in the event of fault conditions. Redundancy often extends beyond the BSC equipment itself and is commonly used in the power supplies and in the transmission equipment providing the A-ter interface to PCU.
Some of the GSM/UMTS Circuit Switched interfaces in the Mobile Switching Center (MSC) transported over SS7 include the following: B -> VLR (uses MAP/B). Most MSCs are associated with a Visitor Location Register (VLR), making the B interface "internal". C -> HLR (uses MAP/C) Messages between MSC to HLR handled by C Interface