Search results
Results from the WOW.Com Content Network
A typical "portable" dehumidifier can be moved about on built-in casters. A dehumidifier is an air conditioning device which reduces and maintains the level of humidity in the air. [1] This is done usually for health or thermal comfort reasons or to eliminate musty odor and to prevent the growth of mildew by extracting water from the air. It ...
Compressed air dryers are special types of filter systems that are specifically designed to remove the water that is inherent in compressed air. The compression of air raises its temperature and concentrates atmospheric contaminants, primarily water vapor, as resulting in air with elevated temperature and 100% relative humidity.
These coolers use air pumps to push the water into the cooling chamber and Peltier devices to chill the water. New development within the water cooler market is the advent of countertop appliances which are connected to the mains and provide an instant supply of not only chilled water but also hot and boiling water.
A pedestal sump pump with a float switch. A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float.
A hot water storage tank where one of the heat sources is solar heating A, that is sent into the hot water storage tank via a smaller pump B (circle with triangle) and the heat exchanger spiral in the hot water storage tank. The other spiral C can be used for a e.g. oil-fired boiler or a wood burner.
Note: These diagrams represent a configuration typical in the USA, mechanisms may vary in other countries [citation needed]. The toilet ballcock, long made of brass and later made of plastic, was superseded by the float cup, pioneered in 1957 by the Fluidmaster founder Adolf Schoepe , which is integrated with the tank’s fill valve and so ...
By contrast, indirect or closed-loop systems do not allow potable water through the panels, but rather pump a heat transfer fluid (either water or a water/antifreeze mix) through the panels. After collecting heat in the panels, the heat transfer fluid flows through a heat exchanger , transferring its heat to the potable hot water.
The leaky bucket is an algorithm based on an analogy of how a bucket with a constant leak will overflow if either the average rate at which water is poured in exceeds the rate at which the bucket leaks or if more water than the capacity of the bucket is poured in all at once.