Search results
Results from the WOW.Com Content Network
Peak values can be calculated from RMS values from the above formula, which implies V P = V RMS × √ 2, assuming the source is a pure sine wave. Thus the peak value of the mains voltage in the USA is about 120 × √ 2, or about 170 volts. The peak-to-peak voltage, being double this, is about 340 volts.
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
Example of a PWI for peak, soak, and slope values The PWI is calculated as the worst case (i.e. highest number) in the set of thermal profile data. For each profile statistic the percentage used of the respective process window is calculated, and the worst case (i.e. highest percentage) is the PWI.
The unit dBov is defined in the ITU-T G.100.1 telephony standard such that the RMS value of a full-scale square wave is designated 0 dBov. [21] [22] All possible dBov measurements are negative numbers, and a sine wave cannot exist at a larger RMS value than −3 dBov without clipping. [21] This unit can be applied to both analog and digital ...
Peak-to-trough ratio in pharmacokinetics is the ratio of peak (C max) and trough (C min) levels of a drug over its dosing interval (τ) at steady state.. Peak-to-trough ratio (PTR), also known as peak-to-trough variation or peak-to-trough fluctuation, is a parameter in pharmacokinetics which is defined as the ratio of C max (peak) concentration and C min (trough) concentration over a dosing ...
In a distribution, full width at half maximum (FWHM) is the difference between the two values of the independent variable at which the dependent variable is equal to half of its maximum value. In other words, it is the width of a spectrum curve measured between those points on the y -axis which are half the maximum amplitude.
The drawdown duration is the length of any peak to peak period, or the time between new equity highs. The max drawdown duration is the worst (the maximum/longest) amount of time an investment has seen between peaks (equity highs). Many assume Max DD Duration is the length of time between new highs during which the Max DD (magnitude) occurred.
Peak-to-peak amplitude (abbreviated p–p or PtP or PtoP) is the change between peak (highest amplitude value) and trough (lowest amplitude value, which can be negative). With appropriate circuitry, peak-to-peak amplitudes of electric oscillations can be measured by meters or by viewing the waveform on an oscilloscope .