Search results
Results from the WOW.Com Content Network
Fig. 1. HSL (a–d) and HSV (e–h). Above (a, e): cut-away 3D models of each. Below: two-dimensional plots showing two of a model's three parameters at once, holding the other constant: cylindrical shells (b, f) of constant saturation, in this case the outside surface of each cylinder; horizontal cross-sections (c, g) of constant HSL lightness or HSV value, in this case the slices halfway ...
HSL (hue, saturation, lightness or luminance), also known as HSI (hue, saturation, intensity) or HSD (hue, saturation, darkness), is quite similar to HSV, with "lightness" replacing "brightness". The difference is that a perfectly light color in HSL is pure white; but a perfectly bright color in HSV is analogous to shining a white light on a ...
In HSV, all triples with value 0 are pure black. If the hue and saturation are held constant, then increasing the value increases the luminance, such that a value of 1 is the lightest color with the given hue and saturation. HSL is similar, except that all triples with lightness 1 are pure white.
The LCh (or HLC) color space is not the same as the HSV, HSL or HSB color models, although their values can also be interpreted as a base color, saturation and lightness of a color. The HSL values are a polar coordinate transformation of what is technically defined RGB cube color space. LCh is still perceptually uniform.
The saturation of a color is determined by a combination of light intensity and how much it is distributed across the spectrum of different wavelengths. The purest (most saturated) color is achieved by using just one wavelength at a high intensity, such as in laser light. If the intensity drops, then as a result the saturation drops.
Chromaticity consists of two independent parameters, often specified as hue (h) and colorfulness (s), where the latter is alternatively called saturation, chroma, intensity, [1] or excitation purity. [ 2 ] [ 3 ] This number of parameters follows from trichromacy of vision of most humans, which is assumed by most models in color science .
Both processes affect the resulting color mixture's relative saturation. A tone is produced either by mixing a color with gray , or by both tinting and shading. [ 1 ] Mixing a color with any neutral color (including black, gray, and white) reduces the chroma , or colorfulness , while the hue (the relative mixture of red, green, blue, etc ...
[clarification needed] Values of S w can range from 0 (dry) to 1 (saturated). In reality, S w never reaches 0 or 1 - these are idealizations for engineering use. The normalized water content, , (also called effective saturation or ) is a dimensionless value defined by van Genuchten [3] as: