Search results
Results from the WOW.Com Content Network
Hirth joint made from anodized aluminum to show the meshing of the teeth Hirth joint (disassembled) between the semi-axles of a Campagnolo Ultra-Torque crankset. Face spline joints consist of a ring of radial splines or teeth milled or ground into the end faces of two rotary components such as a drive shaft and the hub of a wheel.
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
A drive shaft system weighs more than a chain system, usually 0.5–1 kg (1–2 lb) heavier. Many of the advantages claimed by drive shaft's proponents can be achieved on a chain-driven bicycle, such as covering the chain and sprockets. Use of lightweight derailleur gears with a high number of ratios is impossible, although hub gears can be used.
Torque forms part of the basic specification of an engine: the power output of an engine is expressed as its torque multiplied by the angular speed of the drive shaft. Internal-combustion engines produce useful torque only over a limited range of rotational speeds (typically from around 1,000–6,000 rpm for a small car).
Part 1: Brake discs pressed or shrunk onto the axle or drive shaft, dimensions and quality requirements Part 2: Brake discs mounted onto the wheel, dimensions and quality requirements EN 14601: Railway applications — Straight and angled end cocks for brake pipe and main reservoir pipe
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
By rotating the actuator's nut, the screw shaft moves in a line. Wheel and axle: Hoist, winch, rack and pinion, chain drive, belt drive, rigid chain and rigid belt actuators operate on the principle of the wheel and axle. A rotating wheel moves a cable, rack, chain or belt to produce linear motion.