Search results
Results from the WOW.Com Content Network
As Unicode included all the characters in the MSDOS code pages, this had the immediate benefit that all the old MSDOS Alt combinations worked, not just the ones that existed in the Windows Code Page. In the IBM PC Bios typing an Alt code greater than 255 produced the same as that number modulo 256. [3]
A numeric character reference refers to a character by its Universal Character Set/Unicode code point, and a character entity reference refers to a character by a predefined name. A numeric character reference uses the format &#nnnn; or &#xhhhh; where nnnn is the code point in decimal form, and hhhh is the code point in hexadecimal form.
degree symbol ° alt + 0252. check symbol √. alt + 38. and symbol & alt + 7. bullet symbol • alt + 35. number symbol # alt + 247. approximately symbol ≈. alt + 0248. diameter symbol ø. alt ...
Also Alt+0 128 through Alt+0 159 yield the characters assigned in rows 8 and 9 in the CP1252 layout, rather than the C1 control codes that are assigned to those numbers in Unicode. In programs which were not designed to handle Alt codes over 255, the character retrieved usually corresponds to the remainder when the number is divided by 256.
This page lists codes for keyboard characters, the computer code values for common characters, such as the Unicode or HTML entity codes (see below: Table of HTML values"). There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers. The HTML codes can be used where a ...
The standardized keyboard symbol for the Alt key, ⎇ (which may be used when the usual Latin lettering "Alt" is not preferred for labeling the key) is given in ISO/IEC 9995-7 as symbol 25, and in ISO 7000 "Graphical symbols for use on equipment" as symbol ISO-7000-2105. This symbol is encoded in Unicode as U+2387 ⎇ ALTERNATIVE KEY SYMBOL.
Under Windows, the Alt key is pressed and held down while a decimal character code is entered on the numeric keypad; the Alt key is then released and the character appears. The numerical code corresponds to the character’s code point in the Windows 1252 code page, with a leading zero; for example, an en dash (–) is entered using Alt+0150 ...
Geometric Shapes is a Unicode block of 96 symbols at code point range U+25A0–25FF. U+25A0–U+25CF. 25A0 25B0 25C0 Symbol Name Symbol Name Symbol Name Last Hex#