enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. MC4 connector - Wikipedia

   en.wikipedia.org/wiki/MC4_connector

   Among these was the fact that the system had two sets of cables and wires, which led to considerable annoyance in the field when equipment from different vendors could not be plugged together. By 2011, the MC4 was already in a strong leadership position, which led to the introduction of products from a variety of other connector vendors.

3. Aluminum building wiring - Wikipedia

   en.wikipedia.org/wiki/Aluminum_building_wiring

   The splice of the copper pigtail to the existing aluminum wire can be accomplished with special crimp connectors, special miniature lug-type connectors, or approved twist-on connectors (with special installation procedures). Pig-tailing generally saves time and money, and is possible as long as the wiring itself is not damaged.

4. Mineral-insulated copper-clad cable - Wikipedia

   en.wikipedia.org/wiki/Mineral-insulated_copper...

   PVC-sheathed MICC cable. Conductor cross section area is 1.5 mm 2; overall diameter is 7.2 mm. Mineral-insulated cables at a panel board. Mineral-insulated copper-clad cable is a variety of electrical cable made from copper conductors inside a copper sheath, insulated by inorganic magnesium oxide powder.

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   [7]: 40 By definition, each end of this "adapter" has a different connection method – e.g. the solder tabs on a male phone connector, and the male phone connector itself. [3] In this example, the solder tabs connected to the cable represent the permanent connection, whilst the male connector portion interfaces with a female socket forming a ...

6. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Ribbon cable is designed to be used with multi-contact IDC connectors in such a way that many IDC connections can be made at once, saving time in applications where many connections are needed. These connectors are not designed to be reusable, but can often be re-used if care is taken when removing the cable.

8. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   Locking connectors come in a variety of standardized configurations that follow the same general naming scheme except that the designations include an "L" for "locking". Locking connectors are designed so that different voltages and current ratings can not be accidentally intermated. [33] Many specific types exist; only a few are listed below.

9. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Flared connectors should not be confused with compression connectors, which are generally not interchangeable. Lacking a compression ring, they use a tapered conical shaped connection instead. A specialized flaring tool is used to enlarge tubing into a 45º tapered bell shape matching the projecting shape of the flare fitting.