Ads
related to: current controlled switch for water supply meter
Search results
Results from the WOW.Com Content Network
A typical water meter register showing a meter reading of 8.3 gallons. Notice the black "1" on the odometer has not yet fully turned over, so only the red hand is read. Water meters connected to remote reading devices through three-wire cables. There are several types of registers on water meters.
Automatic meter reading (AMR) is the technology of automatically collecting consumption, diagnostic, and status data from water meter or energy metering devices (gas, electric) and transferring that data to a central database for billing, troubleshooting, and analyzing. This technology mainly saves utility providers the expense of periodic ...
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
The typical use of a teleswitch is to manage the start and end times of off-peak charging periods associated with tariffs such as Economy 7 and Economy 10.This includes switching between 'peak' and 'off-peak' meter registers as well as controlling the supply to dedicated off-peak loads such as night storage heating.
The actuator can adjust the phase angle of 0 ° el. (maximum power) up to 180 ° el. (no power). In a 50 Hz mains the controller switches every 20 ms and shows very fast behavior. As a result of the voltage flanks during switch-on, disadvantages such as EMC interference potential or control voltage output also result in ohmic loads.
Since electrical energy is a form of energy that cannot be effectively stored in bulk, it must be generated, distributed, and consumed immediately. When the load on a system approaches the maximum generating capacity, network operators must either find additional supplies of energy or find ways to curtail the load, hence load management.
A current source is an electronic circuit that delivers or absorbs an electric current which is independent of the voltage across it. A current source is the dual of a voltage source. The term current sink is sometimes used for sources fed from a negative voltage supply.
Essentially, the meter's shunt resistor, used to generate a voltage proportional to load current, is replaced by a much larger value, typically 100 times larger, with protective diodes. Readings of the modified meter have to be divided by the resistance factor (e.g. 100), and maximum measurable power is reduced by the same factor.
Ads
related to: current controlled switch for water supply meter