Search results
Results from the WOW.Com Content Network
A staff gauge or head gauge is calibrated scale which is used to provide a visual indication of liquid level. When installed perpendicular to an inclined or sloped surface, a staff gauge is usually calibrated so that the indicated level is the true vertical level .
Hydrostatic pressure level sensors are submersible or externally mounted pressure sensors suitable for measuring the level of corrosive liquids in deep tanks or water in reservoirs. Typically, fluid level is determined by the pressure at the bottom of the fluid containment (tank or reservoir); the pressure at the bottom, adjusted for the ...
The needle gun has advantages over other scaling tools. Its main advantage is that the needles automatically adjust themselves to contours, making the tool a good choice for cleaning irregular surfaces. [2] A needle gun can clean an area to bare metal in seconds, and compares well to other scaling tools in terms of accuracy and precision. [3]
Water gauge on a steam locomotive. Here the water is at the “top nut”, the maximum working level. Note the patterned backplate to help reading and toughened glass shroud. A sight glass or water gauge is a type of level sensor, a transparent tube through which the operator of a tank or boiler can observe the level of liquid contained within.
If the water level is used often, dye can be added to the water to make it easier to see. If the water level is used outdoors in winter, antifreeze can be added to the water. Automotive window washer fluid can also be used for antifreeze and increased visibility. Additionally it inhibits the formation of error-causing bubbles.
Water level gauges: Staff (head) gauges - for a visual indication of water depth; Water pressure measuring device (Bubbler) - to measure water level via pressure (typically done directly in-stream without a stilling well) Stage encoder - a potentiometer with a wheel and pulley system connected to a float in a stilling well to provide an ...
Some ultrasonic cleaners are integrated with vapour degreasing machines using hydrocarbon cleaning fluids: Three tanks are used in a cascade. The lower tank containing dirty fluid is heated causing the fluid to evaporate. At the top of the machine there is a refrigeration coil. Fluid condenses on the coil and descends into the upper tank.
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and time.