Search results
Results from the WOW.Com Content Network
Polycarbonate plastic, which is formed from BPA, is used to make a variety of common products including baby and water bottles, sports equipment, medical and dental devices, dental fillings sealants, CDs and DVDs, household electronics, eyeglass lenses, [6] foundry castings, and the lining of water pipes. [9] BPA is also used in the synthesis ...
Studies have shown that drinking water from plastic bottles has significantly greater detectable plastic content than tap water. [ 40 ] These findings suggest that breastfeeding may inadvertently expose infants to endocrine-disrupting plastics, which could have lasting effects on growth and development.
Polycarbonate is mainly used for electronic applications that capitalize on its collective safety features. A good electrical insulator with heat-resistant and flame-retardant properties, it is used in products associated with power systems and telecommunications hardware. It can serve as a dielectric in high-stability capacitors. [6]
A plastic is considered a bioplastic if it was produced partly or wholly with biologically sourced polymers. A plastic is considered biodegradable if it can degrade into water, carbon dioxide, and biomass in a given time frame (dependent on different standards). Thus, the terms are not synonymous. Not all bioplastics are biodegradable. [44]
Twinwall plastic most commonly refers to two exterior plastic sheets that are connected with a plastic support layer to create parallel channels. This design adds both impact toughness and the ability to support weight. Twinwall plastic may also be used to describe a pipe that has a smooth interior with exterior air filled ridges. [3]
A polycarbonate is an oxocarbon dianion consisting of a chain of carbonate units, where successive carbonyl groups are directly linked to each other by shared additional oxygen atoms. That is, they are the conjugate bases of polycarbonic acids , the conceptual anhydrides of carbonic acid , or polymers of carbon dioxide .
Solution-based polymerization is commonly used today for SAP manufacture of co-polymers, particularly those with the toxic acrylamide monomer. This process is efficient and generally has a lower capital cost base. The solution process uses a water-based monomer solution to produce a mass of reactant polymerized gel.
Poly(glycolide-co-trimethylene carbonate) is a commercial monofilament used for suture with slow biodegradation rate which allows maintenance of high mechanical strength compatible with the surgical recovery. [9] Poly(caprolactone-co-trimethylene carbonate) has been proposed as biomaterial for conduits in the regeneration of central nervous system.