Search results
Results from the WOW.Com Content Network
Electroless nickel immersion gold (ENIG or ENi/IAu), also known as immersion gold (Au), chemical Ni/Au or soft gold, is a metal plating process used in the manufacture of printed circuit boards (PCBs), to avoid oxidation and improve the solderability of copper contacts and plated through-holes.
The thickness of gold plating on jewellery is noted in microns (or micro-meters). The microns of thickness determines how long the gold plating lasts with usage. The jewellery industry denotes different qualities of gold plating in the following terminology Gold flashed / Gold washed - gold layer thickness less than 0.5 micron
Electroless nickel plating, covered by a thin layer of gold, is used in the manufacture of printed circuit boards (PCBs), to avoid oxidation and improving the solderability of copper contacts and plated through holes and vias. The gold is typically applied by quick immersion in a solution containing gold salts.
PCB via current capacity chart showing 1 mil plating via current capacity & resistance versus diameter on a 1.6 mm PCB. In printed circuit board (PCB) design, a via consists of two pads in corresponding positions on different copper layers of the board, that are electrically connected by a hole through the board.
1/2 oz/ft 2 foil is not widely used as a finished copper weight, but is used for outer layers when plating for through holes will increase the finished copper weight Some PCB manufacturers refer to 1 oz/ft 2 copper foil as having a thickness of 35 μm (may also be referred to as 35 μ, 35 micron, or 35 mic).
Ogunjimi et al. [9] looked at the effect of manufacturing and design process variables on the fatigue life of microvias, including trace (conductor) thickness, layer or layers of the dielectric around the trace and in the microvia, via geometry, via wall angle, ductility coefficient of the conductor material, and strain concentration factor ...
Through-hole devices mounted on the circuit board of a mid-1980s home computer.Axial-lead devices are at upper left, while blue radial-lead capacitors are at upper right Close-up view of an electronic circuit board showing component lead holes (gold-plated) with through-hole plating up the sides of the hole to connect tracks on both sides of the board.
An IBM circuit board from a NASA Space Shuttle computer with a conformal coating applied. Conformal coating is a protective, breathable coating of thin polymeric film applied to printed circuit boards (PCBs). Conformal coatings are typically applied with 25–250 μm [1] thickness on electronic circuitry to protect against moisture and other ...