Search results
Results from the WOW.Com Content Network
For example, aligning the rightmost 1 on the C scale with 2 on the LL2 scale, 3 on the C scale lines up with 8 on the LL3 scale. To extract a cube root using a slide rule with only C/D and A/B scales, align 1 on the B cursor with the base number on the A scale (taking care as always to distinguish between the lower and upper halves of the A scale).
Scale ruler. A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale. In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A slide rule consists of a body [note 1] and a slider that can be slid along within the body and both of these have numerical scales inscribed on them. On duplex rules the body and/or the slider have scales on the back as well as the front. [2] The slider's scales may be visible from the back or the slider may need to be slid right out and ...
A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1] Usually, the instrument is rigid and the edge itself is a straightedge ("ruled ...
Technical drawing tool. Drafting tools may be used for measurement and layout of drawings, or to improve the consistency and speed of creation of standard drawing elements. Tools such as pens and pencils mark the drawing medium. Other tools such as straight edges, assist the operator in drawing straight lines, or assist the operator in drawing ...
A basic explanation as to how calculations are performed in a simple four-function calculator: To perform the calculation 25 + 9, one presses keys in the following sequence on most calculators: 2 5 + 9 =. When 2 5 is entered, it is picked up by the scanning unit; the number 25 is encoded and sent to the X register;
Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ″ = 1′ 0″). Site plans are often drawn at 1:200 or 1:100. Scale is a nuanced subject in the use of engineering drawings.
A schematic, or schematic diagram, is a designed representation of the elements of a system using abstract, graphic symbols rather than realistic pictures. A schematic usually omits all details that are not relevant to the key information the schematic is intended to convey, and may include oversimplified elements in order to make this essential meaning easier to grasp, as well as additional ...