Search results
Results from the WOW.Com Content Network
128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART supports 9-bit characters in addition to the 5- to 8-bit characters that other UARTs support. This was introduced by Oxford Semiconductor, which is now owned by PLX Technology.
The file transfer protocol within UUCP is the "g" protocol. [101] MODEM7: Mark M. Zeigler, James K. Mills: 1980: Slight extension of XMODEM to add filename support and batch transfers. [102] XMODEM: Ward Christensen: 1977: Public domain: Very simple protocol that saw widespread use and provided the pattern for many following protocols. [103 ...
Those modems are obsolete, having been replaced by modems which convert asynchronous data to synchronous forms, but similar synchronous telecommunications protocols survive in numerous block-oriented technologies such as the widely used IEEE 802.2 (Ethernet) link-level protocol. USARTs are still sometimes integrated with MCUs.
The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications. The corrected -A version was released in 1987 by National Semiconductor . [ 1 ]
Once the image has been downloaded, devices can be programmed with this memory image without a PC. The Microchip version of PICkit 2 has 128 KB memory as standard. 256 KB memory can be accommodated by modifying the hardware or by using a third-party clone. A 500 kHz three-channel logic analyzer and a UART tool are built into the PICkit 2. These ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
The maximum goodput (for example, the file transfer rate) may be even lower due to higher layer protocol overhead and data packet retransmissions caused by line noise or interference such as crosstalk, or lost packets in congested intermediate network nodes. All protocols lose something, and the more robust ones that deal resiliently with very ...
Since the XMODEM protocol required the sender to stop and wait for an <ACK> or <NAK> message from the receiver, it tended to be quite slow. In the era of 300 bit/s modems, the entire 132-byte packet required 4.4 seconds to send (132 bytes * (8 bits per byte + 1 start bit + 1 stop bit) / 300 bits per second).