Search results
Results from the WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
Consistent Network Device Naming is a convention for naming Ethernet adapters in Linux.. It was created around 2009 to replace the old ethX naming scheme that caused problems on multihomed machines because the network interface controllers (NICs) would be named based on the order in which they were found by the kernel as it booted.
In general, edge devices are normally routers that provide authenticated access (most commonly PPPoA and PPPoE) to faster, more efficient backbone and core networks.The trend is to make the edge device smart and the core device(s) "dumb and fast", so edge routers often include quality of service (QoS) and multi-service functions to manage different types of traffic.
In computer networking, the Link Control Protocol (LCP) forms part of the Point-to-Point Protocol (PPP), within the family of Internet protocols. In setting up PPP communications, both the sending and receiving devices send out LCP packets to determine the standards of the ensuing data transmission.
If you recently changed your AOL password, you'll need to update it in the email client you use. Find your application's "Email Accounts" or "Account Settings" section, select your AOL Mail account, then update to your new password.
On Linux, network block device (NBD) is a network protocol that can be used to forward a block device (typically a hard disk or partition) from one machine to a second machine. As an example, a local machine can access a hard disk drive that is attached to another computer. The protocol was originally developed for Linux 2.1.55 and released in ...
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
An edge connector is the portion of a printed circuit board (PCB) consisting of traces leading to the edge of the board that are intended to plug into a matching socket. The edge connector is a money-saving device because it only requires a single discrete female connector (the male connector is formed out of the edge of the PCB), and they also ...