Search results
Results from the WOW.Com Content Network
The throat halyard hoists the throat of the sail (the end closer to the mast) at the forward end of the gaff and bears the main weight of the sail and the tension of the luff. [5] The peak halyard lifts the aft end of the gaff and bears the leech tension. Small craft attach the peak halyard to the gaff with a wire span with eyes at both ends ...
Traditionally, it was a strong, usually wooden spar extending forward over the bow of a Western sailing ship holding a block through which the tack of the foresail was passed; on some modern sailing yachts with long main booms it is a short spar extending aft from the stern anchoring a central backstay. [2]
Vertical transom and stern of a modern cargo ship. In some boats and ships, a transom is the aft transverse surface of the hull that forms the stern of a vessel. Historically, they are a development from the canoe stern (or "double-ender") wherein which both bow and stern are pointed. Transoms add both strength and width to the stern.
The ship was extensively refitted between January 1931 and January 1934 at a cost of £424,000. During this refit, the aft superstructure was rebuilt and the torpedo-control tower and its rangefinder were removed, together with the aft set of torpedo tubes. The fore funnel was trunked into the aft funnel to reduce smoke in the spotting top.
Below: a lower deck of the ship. [1] Belowdecks: inside or into a ship, or down to a lower deck. [12] Bilge: the underwater part of a ship between the flat of the bottom and the vertical topsides [13] Bottom: the lowest part of the ship's hull. Bow: front of a ship (opposite of "stern") [1]
The clew (back corner) of the sail attaches to the free end of the boom. The entire foot of the sail may be attached to the boom or just the clew. If the foot is not attached to the boom, the rig is known as loose footed. A boom may be found on small headsails. There the forward end of the boom is attached to the same stay as the sail's luff ...
Frame-first construction involves laying down the framework of the vessel before attaching the planks to the boat. This is normally done by erecting a "master frame" in the center of the keel, and deriving the shapes of the other frames using a curved piece of wood stretched between the frame and the end posts, or through a geometric curve.
In place of the afterdeck, a ship may be built with a poop deck, that is a deck that forms the roof of a cabin built in the rear, or "aft", part of the superstructure of a ship; a poop deck is usually higher up than an afterdeck. A ship may have its superstructure or aftercastle located in the stern and thus not have an afterdeck. The stern and ...