enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Specific speed - Wikipedia

    en.wikipedia.org/wiki/Specific_speed

    Specific speed N s, is used to characterize turbomachinery speed. [1] Common commercial and industrial practices use dimensioned versions which are of equal utility. Specific speed is most commonly used in pump applications to define the suction specific speed —a quasi non-dimensional number that categorizes pump impellers as to their type and proportions.

  3. Compressor characteristic - Wikipedia

    en.wikipedia.org/wiki/Compressor_characteristic

    In compressor maximum volume flow rate is limited by cross-section at the inlet. This condition can be seen in the right side of the Figure 5. in which constant speed lines descends steeply. The point on constant speed line at which choking occurs is known as choke point or stonewall point. [16]

  4. Centrifugal pump selection and characteristics - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump_selection...

    Here and depend on the geometric parameters and the rotational speed of the pump and are assumed to be constant for the purpose of comparison. However, this simple linear relationship undergoes modification on account of various losses and a non-linear, decreasing H − Q {\displaystyle H-Q} relationship is seen in the pump characteristic curve.

  5. Centrifugal pump - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump

    Self-priming pumps have to be capable of evacuating air from the pump suction line without any external auxiliary devices. Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935.

  6. Axial-flow pump - Wikipedia

    en.wikipedia.org/wiki/Axial-flow_pump

    An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.

  7. Centrifugal compressor - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_compressor

    The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...

  8. Net positive suction head - Wikipedia

    en.wikipedia.org/wiki/Net_positive_suction_head

    In a hydraulic circuit, net positive suction head (NPSH) may refer to one of two quantities in the analysis of cavitation: The Available NPSH (NPSH A): a measure of how close the fluid at a given point is to flashing, and so to cavitation. Technically it is the absolute pressure head minus the vapour pressure of the liquid.

  9. Blade solidity - Wikipedia

    en.wikipedia.org/wiki/Blade_solidity

    is the specific speed; Cordier diagram can be used to determine specific speed and impeller tip diameter . Accordingly solidity ratio and hub-tip ratio (range 0.3-0.7) can be adjusted. Solidity ratio generally falls in the range of 0.4-1.1