Search results
Results from the WOW.Com Content Network
The torque tube design is typically heavier and securely ties the rear end together, thus providing a rigid rear end and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods, there may be a "little hopping around of the rear end when cornering fast or on washboard roads".
With a beam axle, the camber angle between the wheels is the same regardless of its location in the travel of the suspension. A beam axle's location in the fore and aft directions is constrained by one of several suspension components, including trailing arms , semi-trailing arms, radius rods, and leaf springs .
A similar method like this was used in the late 1930s by Buick and by Hudson's bathtub car in 1948, which used helical springs that could not take fore-and-aft thrust. The Hotchkiss drive , invented by Albert Hotchkiss, was the most popular rear suspension system used in American cars from the 1930s to the 1970s.
It is very rare on modern cars, the Corvette and a few Volvo models being examples. [4] In the past it was more widely used in many Triumphs . The Herald , Vitesse , Spitfire , and GT6 all used a rear transverse leaf spring, as well as the 1995-98 Volvo 960/S90/V90 and a rare Swedish sports car incorporating the Volvo 960 rear suspension called ...
An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps. Although there are many variations in design, the object is to induce a vehicle's body to remain as level as possible by forcing the opposite wheel's shock absorber , spring, or suspension rod in the same ...
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
Modern front-wheel drive cars typically combine the transmission (gearbox and differential) and front axle into a single unit called a transaxle. The drive axle is a split axle with a differential and universal joints between the two half axles. Each half axle connects to the wheel by use of a constant velocity (CV) joint which allows the wheel ...
Media in category "Images of cars" The following 24 files are in this category, out of 24 total. ... POBJFK Car on Roof.jpg 604 × 453; 29 KB. Rx7 front.jpg 760 × ...