Search results
Results from the WOW.Com Content Network
powerbutton put the machine to sleep when the power button pressed instead of shutting it down, 1 to enable or 0 to disable; powernap lets machine stay up to date even while they're sleeping, 1 to enable or 0 to disable; lidwake (laptop only) wake the machine when the laptop lid is opened, 1 to enable or 0 to disable
A real time clock alarm is a feature that can be used to allow a computer to 'wake up' after shut down to execute tasks every day or on a certain day. It can sometimes be found in the 'Power Management' section of a motherboard's BIOS/UEFI setup. Wake On LAN, Wake on ring, and IPMI functions could also be used to start a computer after it is ...
IEC 60417-5008, [7] the power-off symbol (circle) on a button or toggle, indicates that using the control will disconnect power to the device. (0 or means off.) IEC 60417-5009, [8] the standby symbol (line partially within a broken circle), indicates a sleep mode or low power state. The switch does not fully disconnect the device from its power ...
[21] [22] On 28 February 2020, Apple agreed to a $500 million settlement in a California court, under which it plans to pay at least $25 to all U.S. residents who had purchased an iPhone 6, 6 Plus, 6S, 6S Plus, SE, 7 or 7 Plus device . [23] A separate investigation from 34 states and the District of Columbia also looked into the battery practice.
The method by which a sleep proxy server wakes a sleeping host is wake-on-LAN. The network interface of a sleeping host with this capability will wake the machine when it receives a specific series of bits, and a packet containing this pattern is a magic packet. Early implementations of Wake on LAN (WoL) required
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot.
DevSlp or DevSleep (sometimes referred to as device sleep or SATA DEVSLP) is a feature in some SATA devices which allows them to go into a low power "device sleep" mode when sent the appropriate signal, which uses one or two orders of magnitude less power than a traditional idle (about 5 mW, [1] but some drives can get as low as 2.5 mW [2]).
Wake-on-LAN can, however, operate across any network in practice, given appropriate configuration and hardware, including remote wake-up across the Internet. In order for Wake-on-LAN to work, parts of the network interface need to stay on. This consumes a small amount of standby power. To further reduce power consumption, the link speed is ...