enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Workbench (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Workbench_(woodworking)

   A form of bench dog, a traditional holdfast has either a curved or flat top. Its shank is slid loosely into a “dog” hole in the bench until the tip of its hook touches the work. It is set by hitting its top with a mallet or hammer, which causes the shaft to wedge tightly against the sides of the hole. A tap of its back side near the top ...

3. Bench dog - Wikipedia

   en.wikipedia.org/wiki/Bench_dog

   A bench dog is a removable clamp used on a woodworking workbench to hold an item fast while being worked. It is characteristically used in concert with an adjustable dog on a bench vise , allowing an item compressed between the two to be held fast on each end, and if offset in both directions.

4. Holdfast (tool) - Wikipedia

   en.wikipedia.org/wiki/Holdfast_(tool)

   A form of bench dog, a traditional holdfast has either a curved or flat top. Its shank is slid loosely into a “dog” hole in the bench or anvil until the tip of its hook touches the work. It is set by hitting its top with a mallet or hammer, which causes the shaft to wedge tightly against the sides of the hole. A tap of its back side near ...

5. Dog (engineering) - Wikipedia

   en.wikipedia.org/wiki/Dog_(engineering)

   This word usage is a metaphor derived from the idea of a dog (animal) biting and holding on, the "dog" name derived from the basic idea of how a dog jaw locks on, by the movement of the jaw, or by the presence of many teeth. In engineering the "dog" device has some special engineering work when making it – it is not a simple part to make as ...

6. Black & Decker Workmate - Wikipedia

   en.wikipedia.org/wiki/Black_&_Decker_Workmate

   It can be used as a bench vice to hold wood, metal and other parts, either clamped between the jaws or, using supplied bench dogs, clamped on the table top. The jaws are wide enough to hold most bench top tools, such as a drill press, planer, miter saw, etc. [ 1 ]

7. J.H. Williams Tool Group - Wikipedia

   en.wikipedia.org/wiki/J.H._Williams_Tool_Group

   Snap-on Industrial Brands, historically J.H. Williams Tool Group, is a division of American hand tool manufacturer Snap-on that makes and distributes tools to industrial markets. In addition to the Williams brand from which it originated, the group includes Bahco and CDI Torque Products .

8. Crown molding - Wikipedia

   en.wikipedia.org/wiki/Crown_molding

   Crown moulding (interchangeably spelled Crown molding in American English) is a form of cornice created out of decorative moulding installed atop an interior wall. It is also used atop doors, windows, pilasters and cabinets .

9. Cope and drag - Wikipedia

   en.wikipedia.org/wiki/Cope_and_drag

   The pins are then carefully pulled out of the sand. The critical part of the operation is to separate the cope and drag to remove the pattern. The pattern may be vibrated with a powered vibrator, or the pattern, and maybe the cope and drag flask, will be lightly tapped with a small hammer. The pattern is lifted from the sand, leaving a molding ...