Search results
Results from the WOW.Com Content Network
Plaster veneer may also be applied to ordinary drywall, or over existing walls, but this requires "gluing" the existing wall surface by painting on a special adhesive compound, and then applying a thin layer of "base coat" plaster. After the blueboard or base coat covers the interior of a room, the finishing plaster is mixed in batches ...
A finish coat that typically uses colorfast and crack-resistant acrylic co-polymer technology. [12] If an EIFS with Drainage, or water-managed EIFS is installed, a water resistive barrier (aka a WRB) is first installed over the substrate (generally glass faced exterior-grade gypsum sheathing, oriented strand board (OSB) or plywood). [16]
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
Stucco marble was an artificial marble made using gypsum (sometimes with lime), pigments, water and glue. Stucco lustro was another a form of imitation marble (sometimes called stucco lucido) where a thin layer of lime or gypsum plaster was applied over a scored support of lime, with pigments scattered on surface of the wet plaster.
The plaster is applied in two coats to slow the drying speed of the second coat and after drying must still be wetted and worked for a time to produce a thin film of watery plaster which has the effect of "Polishing" the finished surface. This finishing plaster is normally trowelled on two or three passes to achieve this.
The traditional application of stucco and lath occurs in three coats—the scratch coat, the brown coat and the finish coat. The two base coats of plaster are either hand-applied or machine sprayed. The finish coat can be troweled smooth, hand-textured, floated to a sand finish or sprayed.
Lath seen from the back with white plaster coat oozing through Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood ( laths ) which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster .
Plaster spraying allows a plasterer to skim a drywall more than five times faster than using a hand float to apply it. Although classic gypsum-based plaster can be sprayed if it is "spray grade," most plaster sprayers prefer the organic-based pre-mixed plaster packaged in a plastic bag because the plaster spraying machine does not need to be cleaned out after the job is finished, providing ...